I was hoping to install a 7.1 system in my basement, but due to room logistics, I'm having to settle with 6.1. Since a 6.1 system uses 3 rears instead of 2 sides and 2 rears, will this affect the calibration on a 7.1 receiver using XT32?
Have more questions? Submit a request
-
Rob Brooks Audyssey measure what it sees connected to the terminals
As long as your AVR is capable of runnign in a 6.1 config.i.e
my Denon requires you to connect a single surround-rear to the Surr-Rear-Left channel for a 6.1 setup
if you connect it to the right, it thinks you're trying to run in a 7.1 config but have not connected the left back channel
Article is closed for comments.
1 Comments